MacroMachines shows you how he made a very simple louver press for punching louvers in 1/16″ aluminum. This is the simplest way to make one of these presses, and it works really well even on large panels…
How To Make a Simple Louver Press
This site contains affiliate links for which we may be compensated.
How To & DIY
How To Install Holley Sniper EFI
Holley Sniper EFI is perfect for hot rods, street rods, muscle cars, off-road trucks or nearly any carbureted vehicle. [More…]
How To & DIY
1949-54 GM Torque Tube to Open Driveshaft Conversion Donor Vehicles
The primary complaint about an enclosed torque tube driveline is that there are very limited ratios available for the rear end. [More…]
DIY Projects
How To Chop a 1947 Buick Sedanette in Two Minutes
It took Kjetil Kvipt and his Coupe Devils car club members 9 hours to chop the top on Hans Ola Christensen’s 1947 Buick Sedanette. [More…]