Bad Chad shares insights and explains rear-end fabrication and how to ensure proper welding of frame components…
Bad Chad on Rear-End Fabrication and Welding Frame Components
This site contains affiliate links for which we may be compensated.
How To & DIY
How To Rebuild a GM 10 Bolt Chevy 8.5″ Rear End
Tinman 2 Kustoms shows how to rebuild a 10 bolt Chevy 8.5″ rear axle in the bagged C10 using Yukon Gear & Axle components. [More…]
Automotive Basics
How To Determine Engine/Pinion Angle
Engine and pinion angle are relative to the ground. Most engines are set at 3 degrees, this allows the carburetor to sit level, however… [More…]
Technical Info
Big Vehicle Overdrive ~ 4L80E Transmission Basics
When your big engine and TH400’s lack of overdrive has your engine screaming on the highway, a 4L80E transmission might just be the answer. [More…]