The legend himself — Gene Winfield — gives a metal working demonstration at the SEMA Show in Las Vegas. This is a “must watch” for newbies and veterans alike…
Metal Forming, Tools and Uses Explained By Gene Winfield
How To & DIY
How To Replace C10 Truck Inner & Outer Rocker Panels
Eastwood helps with rust repair needed on this Chevy C-10 restoration. The inner and outer rocker panels get replaced… [More…]
How To & DIY
How To Insure, Appraise, Title and Register Your Hot Rod
Getting your hot rod properly titled, registered and insured can be one of the most demanding aspects of the project and will vary according to the vehicle and your state. In some states it’s quite a challenge to register a newly built rod, so it’s a smart idea to do some preliminary research early into the project. [More…]
Home Garage
14 DIY Tools and Ideas You Can Make At Home
14 DIY Tools and Ideas that can be hand-made at home, with scrap metal and basic hardware using shop and hand tools. [More…]
