This helpful video tutorial simply demonstrates step-by-step how to bench bleed a new master cylinder…
Master Cylinder Installation and Bench Bleeding Procedure
DIY Projects
How and Where To Score a Cheap Junkyard Engine
For generations hot rodders have pulled bigger and more powerful engines out of other cars to use in their DIY hot rod projects. Back in the ’50s gearheads would spend hours hunting for Cadillac and Oldsmobile engines to use in their rods. In the ’60s builders started pulling Hemis, Pontiac 455s, Ford Cammers, and of course the big-block Chevys out of cars to power their gassers, T-buckets and other custom powered street machines. [More…]
How To & DIY
How To Insure, Appraise, Title and Register Your Hot Rod
Getting your hot rod properly titled, registered and insured can be one of the most demanding aspects of the project and will vary according to the vehicle and your state. In some states it’s quite a challenge to register a newly built rod, so it’s a smart idea to do some preliminary research early into the project. [More…]
How To & DIY
GM LSx Engine Swap ~ Wiring Harness Preparation
By Jay Kopycinski — There was a time when many hot rod enthusiasts were afraid of electronic fuel injection (EFI) on engines, preferring the “relative simplicity” of a carbureted engine that could be run in a [More…]
