An inch micrometer is used to make precise measurements to the thousandth of an inch. Here is how to read… Read More
Take the guesswork out of your chassis setup with the free TREMEC Driveline Angle Finder using your smartphone as a… Read More
Shift Knob and Handle Thread Sizes may vary on vehicle make, model, and trim level, and whether it is OEM,… Read More
Specs include overall height, length, and width of a fully dressed engine - oil pan, intake, carburetor, front accessory drives,… Read More
Engine and pinion angle are relative to the ground. Most engines are set at 3 degrees, this allows the carburetor… Read More
Whether you're a professional just getting started, reading a tape measure correctly is key to parts that fit and solid… Read More
You'll need the diameter and width, lug or bolt pattern, and offset. When a custom set of wheels is being… Read More
Here's how you can tell the difference between the grade, thread pitch, diameter, and length of the bolt. [More...] Read More
A guide for exhaust-pipe tube size needed to balance prevention of excessive back-pressure while maintaining adequate exhaust-gas velocity. [More...] Read More
Learn The Right Way To Measure for Wheel Size Before You Place An Order: Bolt Pattern, Wheel Width, Backspacing... [More...] Read More